Calcium silicate gluing.
Calcium silicate (kalkzandsteen) is the most widely used block for interior walls and inner leaves of cavity walls in Dutch house building. We glue the walls to drawing: plumb, to size and with the openings in the right place, so the next crew can carry on straight away.
What is calcium silicate gluing?
Calcium silicate is made from sand, lime and water and is the most widely used block in the Netherlands for interior walls, inner leaves of cavity walls and party walls. With calcium silicate gluing, the blocks or elements are not bricklaid but glued with a thin layer of mortar. The joint is only about two millimetres thick.
The result is a flat wall, true to size, that goes up fast. Thanks to its high mass, calcium silicate absorbs sound well, the block is non-combustible and it retains heat for a long time.
Glue blocks or elements?
There are two ways of working for calcium silicate gluing. Glue blocks are easy to handle and are laid by hand: suitable for an extension, a garage or interior walls in a renovation. Elements are much larger and are placed with a block-laying crane: the choice for housing and apartments, where a lot of straight wall has to go up in a short time.
What does calcium silicate gluing cost?
The price of gluing work depends on the number of square metres of wall, the thickness and type of block or element, the wall height, the number of openings and infill pieces and access to the building site. We make a no-obligation quote based on your construction drawing.
Suitable for
- New-build houses and apartments
- Extensions, rear extensions and added storeys
- Party walls and load-bearing walls
- Inner leaves of cavity walls and interior walls
Frequently asked questions about calcium silicate gluing
Why glue calcium silicate instead of bricklaying?
Gluing is faster, gives a flatter wall and a thinner joint. The wall is therefore true to size and can often be finished with a thin finish.
What do you need to start?
A flat, load-bearing base, the construction drawings and the material on site. Anything else we agree is stated in the quote.
Can a glued calcium silicate wall be load-bearing?
Yes. Calcium silicate has a high compressive strength and is widely used for load-bearing interior walls and inner leaves of cavity walls. The thickness and strength class needed follow from the structural engineer's calculation.
How is a glued wall finished?
Because a glued wall is flat, a thin finish is often enough, such as spray plaster, thin plaster or a wallpaper-ready finish.
Step by step.
Setting the kim course
The first course is set in mortar, level and at the right height. A good kim course sets the whole wall.
Gluing
The blocks or elements are glued with thin-bed mortar, with full bed and head joints where specified.
Ties and movement joints
Cavity ties, wall connections and movement joints are fitted according to the installation instructions.
Check
We check dimensions, plumb and flatness and hand over the wall neatly.